|
Race-Dezert.com Promotion! CST Performance Suspension 6-8" 1500HD and 2500 Lift Kit! CST has again outdone themselves with their 2001-2007 Silverado and Sierra 1500HD and 2500HD (Heavy Duty) suspension lifts. Based on the design and success of the original CST Silverado 6-8" lift kit, CST offers a true 6" lift for the 4x4 GM HD series trucks. These 1500HD and 2500HD lifts utilize the famous CST 6" welded subframe drop-down brackets that have made CST lift kits known around the world as the strongest kits money can buy. Dependability and reliability is built into every CST kit and this HD series kit really is HEAVY DUTY! The upper control arm is dropped to help maintain the stock geometry. Dropping the upper arm also allows CST to keep the front track width as close as stock to possible. Other kit manufacturers like Fabtech, Rancho, and RCD, all increase the front track width. The CST kit will even allow you to run stock wheels if you want! By retaining the factory front end width the fenders do a better job of covering the tires, preventing road debris from damaging your vehicles paint. At 6 inches of lift the CST kit has perfectly flat front axle shaft angles. This allows you to adjust ride height by an additional two inches without damaging the CVs. This CST feature allows HD owners to adjust vehicle height between 6 and 8 inches of lift. This is nice because you can custom tailor the lift height to your own preference. This 6 - 8" HD lift kit includes all necessary hardware to lift the vehicle 6 inches... if you wish to achieve 8" inches of total lift you must also install the torsion lift keys. PerformanceLifts.com is including this for FREE when purchased during the Race-Dezert.com promotion. CST includes a 5" rear lift block and u-bolt kit to raise the rear. If you raise the front the full 8" inches a rear spring pack is recommended if you want to level the truck. With 8" of front lift and a 5" block lift you will end up with a "prerunner" stance with the rear lower than the front. Note: The majority of 2500HD series 4wd trucks equipped with the Allison transmission do NOT need a replacement front driveshaft. All 4x4 1500HD and 2500HD vehicles not equipped with the Allison transmission must purchase the CST replacement dual cardan driveshaft to prevent front driveline vibration. Note: CST Performance Suspension shocks are included with this kit! That's right, Race-Dezert.com readers receive a set of four CST Performance Suspension brand shock absorbers for free with the purchase of the CST 6-8" kit! This is a savings of over $359.00 and is only available for a limited time during the Race-Dezert.com promotion! For additional information please click on the "ask a question" link located at the very top of this page. Be sure to mention the Race-Dezert.com promotion! This item ships for FREE via standard ground service to all addresses located in the 48 contiguous United States of America!
|
