Fabtech 2018+ Jeep Wrangler JL 3" Trail System - Stealth Shocks # K4117M
Manufacturer | Fabtech Motorsports |
---|---|
Part Number | K4117M |
Vehicle Year | 2018 |
Vehicle Make | Jeep |
Vehicle Model | Wrangler JL |
Drive Type | 4-Wheel Drive |
Made In USA | Yes |
Fabtech 2018+ Jeep Wrangler JL 4-Door 3" Trail System with Stealth Shocks # K4117M. This lift is designed specifically for 4-Door models equipped with the 6-cylinder gasoline (petrol) engine. This popular system is a top choice for daily drivers that enjoy tackling tough trails and overlanding with the comfort that they have a high quality complete suspension under their Jeep. Each Fabtech component has been designed with specific features and benefits that create this quality suspension system. For a greater understanding of each these components please see below.
Fabtech’s long travel Dual Rate coil Springs are corner specific to the JL. This keeps the vehicle level side to side and allows for increased suspension travel. The first stage of the spring provides a soft ride with the ability to extend for additional travel. The second stage is designed to handle the payload of the vehicle and address large impact absorption at higher speeds.
To address the steering geometry with the increased ride height, a Draglink Flip System along with a heavy duty Track Bar bracket is included. This relocates the steering geometry to the factory plane allowing for full articulation without binding the draglink ends in extreme conditions. The factory angle of the draglink to the pitman arm does not change and there is no increased side load on the steering box sector shaft as compared to using a dropped pitman arm. This helps extends the life of the steering box with the increased ride height.
The heavy duty rear Track Bar bracket with side support maintains the factory roll center of the vehicle while centering the axle. Front and rear bumps stop extensions protect the suspension from over cycling.
Wheel & Tire Info:
For the most part the Jeep Wrangler JL clears larger tires better than the previous JK with the same amount of lift. With this Fabtech 3" Lift installed the largest recommended tire size is 35" inches. Using a wide wheel or a wheel with different than recommended back space may cause rubbing issues. Our advice? Stick with the recommended 35" tires unless you are willing to go through the additional work to properly clear a larger tire. Please take note that the following information is Stock Fender or Aftermarket High Clearance Fender specific:
Stock Fenders:
35/12.50R17 Wheel Size 17X9 w/ 4.5in BS w/minor trimming
35/12.50R17 Wheel Size 18X9 w/ 4.5in BS w/minor trimming
325/65R18 Wheel Size 18X9 w/ 4.5in BS w/minor trimming
35/12.50R20 Wheel Size 20X9 w/ 5in BS w/minor trimming
325/60R20 Wheel Size 20X9 w/ 5in BS w/minor trimming
High Clearance Fenders:
37/12.50R17 Wheel Size 17X9 w/ 4.5in BS w/cutting
37/12.50R18 Wheel Size 18X9 w/ 4.5in BS w/cutting
37/12.50R20 Wheel Size 20X9 w/ 5in BS w/cutting
Fabtech K4117M Kit Contents:
1 x FTS24205 - FRONT & REAR LONG TRAVEL COILS
1 x FTS24208 - FRONT & REAR SHORT ARM LOWER LINKS
1 x FTS24209 - LONG TRAVEL BOX KIT
1 x FTS24210 - DRAG LINK KIT
2 x FTS6349 - Front Stealth Monotube
2 x FTS6352 - Rear Stealth Monotube
This item ships for FREE via standard ground service to any address located in the lower 48 United States of America!
Manufacturer | Fabtech Motorsports |
---|---|
Part Number | K4117M |
Vehicle Year | 2018 |
Vehicle Make | Jeep |
Vehicle Model | Wrangler JL |
Drive Type | 4-Wheel Drive |
Made In USA | Yes |