Shopping Cart Contents...
PRG Products Nissan Titan 2004-2015 Rear Lift Block & U-Bolt Kit. This lift block is most often required after a front suspension lift or leveling kit has been installed and the truck needs additional rear height to achieve the desired stance. Performance Lifts customers have asked for an inexpensive way to safely raise the rear of their Titan truck and here it is! We prefer these PRG Products solid aluminum blocks over cast iron blocks for a number of reasons. The PRG Blocks are solid aluminum and will not crack at the locating pin like cast iron blocks are prone to doing. PRG blocks will not rust like an iron block. The PRG Blocks are lighter than a similar size cast iron block. These blocks are built specifically for use with the Titan and are the correct length and width for the factory spring perch and leaf spring.
Titan 2wd Owners: The 2wd Nissan Titan uses a 2-piece rear drive shaft equipped with a carrier bearing. If you are lifting the rear of your Titan 3" inches or more you may need to install a Carrier Bearing Drop Bracket to eliminate rear drive line vibration. This is NOT necessary on 4x4 models! If you are installing this PRG Block Kit on a 2wd Titan already equipped with a rear lift (add-a-leaf, mini-pack, etc) please keep this in mind. PRG Products Block Kits include a set of longer U-bolts and all required installation hardware. The factory U-bolt hardware will not be reused. PRG Lift Blocks are machined from solid 6061 Aluminum bar stock and have a steel centering pin as shown.
Please be sure to select the desired PRG Rear Block Lift Height using the selection boxes located above this item description. For more information on this or any other item, please click on the "ask a question link" located at the very top of this page.
|Free Shipping||Free Ground Shipping!|
|Vehicle Year||2016, 2015, 2014, 2013, 2012, 2011, 2010, 2009, 2008, 2007, 2006, 2005, 2004|
|Made In the USA||Yes|