PRG 2005+ Nissan Frontier & XTerra Transmission Mount - 4x4 Only!
This PRG Products item requires approximately 7-10 days to ship once ordered.
This PRG Products Transmission Mount is designed as an upgrade for 2005, 2006, 2007, 2008, 2009, 2010, 2011, 2012, 2013, 2014, 2015, 2016, 2017, 2018, 2019, 2020 and 2021 Nissan Frontier 4x4 and 2005 - 2015 Nissan Xterra 4x4 vehicles equipped with the Automatic Transmission. Please note, this item will NOT fit 2wd or manual transmission equipped models! The factory Nissan Automatic Transmission mount has been proven to be inadequate and is prone to failure. In most cases the rubber will tear away from the mount and at that point the entire mount must be replaced. Aggressive driving and larger than stock tires can place more stress on the factory mount than it can handle. Some customers are having to replace the factory mount every 10,000 miles or so. At a dealer cost of around $100.00 for the parts alone this can become a very expensive and time consuming problem. The solution is to replace the factory Nissan parts with this PRG Products Transmission Mount Upgrade.
Keep reading below for more product information...
Manufacturer | PRG Products |
---|---|
Part Number | PRGNFXTM |
Vehicle Year | 2015, 2014, 2013, 2012, 2011, 2010, 2009, 2008, 2007, 2006, 2005 |
Vehicle Make | Nissan |
Vehicle Model | Frontier, Xterra |
Drive Type | 4-Wheel Drive |
Made In USA | Yes |
The PRG Products 2005 - 2021 Nissan Frontier & 2005 - 2015 Nissan Xterra Transmission Mount design uses a Urethane bushing captured inside a metal tube. It is impossible for the urethane in the PRG mount to tear away from the tube like the factory rubber insert does. The Urethane bushings used in the PRG Products design are replaceable should it ever wear out. The chances are the rest of the truck will wear out long before the PRG urethane insert does. PRG is so confident in their design that they are offering a limited Lifetime Warranty on this product!
All required installation hardware is included. Installation of this mount requires removal of the factory Nissan mount. The easiest way to remove the factory mount is to cut the studs and then slip the mount out from between the bottom of the transmission and the crossmember support. Removal of the crossmember is in most cases more difficult than cutting the studs. Welding is not required. The Urethane insert used in this PRG Products Trans Mount has a slightly higher durometer than the factory mount. This increase in Urethane bushing material firmness is part of what makes the PRG Transmission Mount so much stronger than the original Nissan design. After installing the PRG Transmission Mount you may notice a small increase in the amount of energy (in the form of vibration) being transferred from the engine and driveline to the chassis. The increase in vibration is minimal and in most cases is not noticed. If you are looking for a solution to cracked or broken factory mounts this is it!
For more information on this or any other PRG Products we ask that you please click on the "ask a question" link located at the very top of this page.
This item ships for FREE via standard service to all 50 United States of America!
Manufacturer | PRG Products |
---|---|
Part Number | PRGNFXTM |
Vehicle Year | 2015, 2014, 2013, 2012, 2011, 2010, 2009, 2008, 2007, 2006, 2005 |
Vehicle Make | Nissan |
Vehicle Model | Frontier, Xterra |
Drive Type | 4-Wheel Drive |
Made In USA | Yes |