PRG 2004-2021 Nissan Titan Transmission Mount - 4x4 Only!
This PRG Products item is built to order and requires 10 - 14 days before it is ready to ship.
This PRG Transmission Mount Upgrade is designed to fit all 2004 - 2015 and 2017+ Nissan Titan 4x4 trucks. Please note, this item will NOT fit XD or any 2wd models! The factory Nissan Automatic Transmission Mount has been proven to be inadequate and is prone to failure. In most cases the rubber will tear away from the mount and at that point the entire mount must be replaced. Aggressive driving and larger than stock tires can place more stress on the factory mount than it can handle. Some customers are having to replace the factory mount every 10,000 miles or so. At a dealer cost of around $100.00 for the parts alone this can become a very expensive and time consuming problem. The solution is to replace the factory Nissan parts with this PRG Products Transmission Mount Upgrade.
Keep reading below for more product information...
Manufacturer | PRG Products |
---|---|
Part Number | PRGNTTM |
Vehicle Year | 2021, 2020, 2019, 2018, 2017, 2016, 2015, 2014, 2013, 2012, 2011, 2010, 2009, 2008, 2007, 2006, 2005, 2004 |
Vehicle Make | Nissan |
Vehicle Model | Titan |
Drive Type | 4-Wheel Drive |
Made In USA | Yes |
The PRG Products Nissan Titan Transmission Mount is designed for use on 2004-2015 and 2017+ Nissan Titan trucks. This product does NOT fit XD or any 2wd models. PRG uses Urethane bushings captured inside a steel tube. It is impossible for the Urethane bushings in the PRG mount to tear away from the tube like the factory rubber insert does. The Urethane bushings used in the PRG Products design are replaceable should they ever wear out. The chances are the rest of the truck will wear out long before the PRG urethane bushings do. PRG is so confident in their design that they are offering a limited Lifetime Warranty on this product!
All required installation hardware is included. Installation of this mount requires removal of the factory Nissan mount. The easiest way to remove the factory mount is to cut the studs and then slip the mount out from between the bottom of the transmission and the crossmember support. Removal of the crossmember is in most cases more difficult than cutting the studs. Welding is not required. The Urethane insert used in this PRG Products Trans Mount has a slightly higher durometer than the factory mount. This increase in Urethane bushing material firmness is part of what makes the PRG Transmission Mount so much stronger than the original Nissan design. After installing the PRG Transmission Mount you may notice a small increase in the amount of energy (in the form of vibration) being transferred from the engine and driveline to the chassis. The increase in vibration is minimal and in most cases is not noticed. If you are looking for the best solution to cracked or broken factory mounts this is it!
For more information on this or any other PRG Products we ask that you please click on the "ask a question" link located at the very top of this page.
This item ships for FREE via standard service to all 50 United States of America!
Manufacturer | PRG Products |
---|---|
Part Number | PRGNTTM |
Vehicle Year | 2021, 2020, 2019, 2018, 2017, 2016, 2015, 2014, 2013, 2012, 2011, 2010, 2009, 2008, 2007, 2006, 2005, 2004 |
Vehicle Make | Nissan |
Vehicle Model | Titan |
Drive Type | 4-Wheel Drive |
Made In USA | Yes |