Click here to ask a question

Tech Support Sales: (949) 629-3017 - Open M-F 9:00am to 5:00pm Pacific

Free shipping on most orders!

PRG Toyota Tundra Rear Lift Block & U-Bolt Kit

Available Lift Heights = 1.00" / 1.50" / 2.00"

This PRG Products rear block lift is designed to fit all 1999-2012 model year 2wd and 4wd fullsize Toyota Tundra pickup trucks. This PRG Rear Block and U-bolt kit is a great way to raise the rear of the Tundra because it's fairly inexpensive and it's very reliable. Rear lift blocks are most often installed after a front suspension lift or leveling kit has been installed and the truck needs additional rear lift to achieve a level stance. Our customers have asked for an inexpensive way to safely raise the rear of their Toyota Tundra and here it is! We prefer these PRG Products solid Aluminum blocks over cast iron blocks because the solid blocks are much less likely to crack at the locating pin. Shorter height cast blocks are known for cracking because there is insufficient material near the centering pin hole. With PRG Billet Blocks this weakness is eliminated. Keep reading below for more information...

Sign up for price alert

Availability: In stock


* Required Fields

PRG Products

Safe, Secure, Trusted Seller



Because the PRG Products block is solid you will need to remove the 2nd roll pin if your Tundra leaf is equipped with one. If your Tundra has this second pin you will need to remove it in order to allow the leaf spring to properly seat on the PRG Products Lift Blocks. This can be accomplished using a hammer and punch to drive the pin downward and then pliers to twist it out. This pin is NOT threaded but rotating it while pulling on it makes removal a little easier. The small amount of additional work required to remove these pins is worth it as you end up with a much stronger block lift installed on the truck.

These PRG Products Rear Lift Block Kits are compatible with the factory Toyota rear shocks. Extended length shock absorbers are not required when installing this Lift Block by itself. If you are adding this PRG 1" Rear Lift Block Kit to an existing rear lift you have previously installed (add-a-leaf, mini-pack, shackle, etc) you will need to verify that your Rear Shocks are of sufficient length.

Please note that this PRG Products Block & U-Bolt Kit includes a set of longer U-bolts and all required U-bolt installation hardware. Your stock Toyota U-bolt hardware will not be reused. The PRG Products Lift Blocks are machined from solid 6061 Aluminum bar stock and have a black centering pin threaded into the center of the block as shown.

For more information on this or any other PRG Products item please click on the "ask a question link" located at the very top of this page.

Additional Info

Additional Info

Free Shipping Free Ground Shipping!
Manufacturer PRG Products
Part Number PRGTTBK
Vehicle Make Toyota
Vehicle Model Tundra
Vehicle Year 2013, 2012, 2011, 2010, 2009, 2008, 2007
Drive Type 2-Wheel Drive, 4-Wheel Drive
Made In the USA No
Installation Guide No
Current Rebates No


Write Your Own Review

Only registered users can write reviews. Please, log in or register