SPC 2007 - 2021 Toyota Tundra Upper Control Arm Kit # 25490

SPC Toyota Tundra Upper Control Arm # 25490. Fits 2007 - 2021 Toyota Tundra 2wd and 4x4 trucks. The SPC hybrid tubular and forged steel design is tough enough to race - on or off-road. If your stock upper control arms had sufficient travel in the ball joint these SPC arms will not be the limiting factor to suspension travel! The OEM style sealed high-angle ball joint allows for sufficient travel without the squeaks and rattles commonly caused by un-sealed Uniball-style arms. The hybrid tubular steel design is tough enough to survive even the harshest usage. These SPC arms can be used in conjunction with the factory alignment cams to maximize clearance in the wheel well.

NEW SpecRide Bushings
Free Moving Pivot Sleeve which eliminates failures caused by high travel suspensions
Noise and vibration control
Ozone, oil and alkaline resistant material
Front Adjustment range: Camber +/-2.00 degrees, Caster 0.0 degree to +4.00 degrees
Installation time: Approximately 1 hour per side

Improve droop travel, drivability and tire wear as well as adjusting tire position in your wheel well with SPC’s adjustable front upper control arms. Featuring an upgraded greaseable ball joint and SpecRide™ bushings, this arm is designed to correct alignment angles while maintaining factory ride quality. SPC's integrated tubular and cast steel designs provide the strength and durability needed for the most demanding environments. These remove and replace arms are sold in pairs.

Get more droop travel: SPC’s arm has improved clearance to get around the spring bucket. With 80° of articulation in the upgraded ball joint and free pivoting bushings, SPC's arm gives you maximum droop travel.

Get your drivability and tracking back: When you lift your truck you affect caster and camber. SPC’s arms have +1° of caster built into them. Using its patented ball joint design the arm will get you 0° to +4° of caster and ±2° of camber, so you can put your alignment angles back to specification.

Get your tire where you want it in the wheel well: Use adjustment in the control arm and on the OE lower cams to maximize alignment angles and move oversized tires forward in the wheel well to minimize or avoid fender trimming.

For more information on this or any other Specialty Products Company product please click on the Ask A Question link located at the very top of this page.

This item ships for free via standard ground service to any address in the contiguous 48 United States of America!