Fabtech 2019 - 2020 Ford Ranger 3.5 Lift System 4x4 # K2323

Fabtech 3.5" Lift System for 2019 and 2020 Ford Ranger 4x4 trucks. By increasing the ride height and installing new offset Intrusion Beams this Fabtech system allows you to run a 33" diameter tire without rubbing. Replacement Fabtech Upper Control Arms address the front suspension geometry after the ride height is increased which means the alignment will be correct. This ensures better tire wear and better handling. Fabtech heavy duty ball joints allow for extended suspension travel without binding. The system has been designed to ensure proper CV axle angle and plunge thus eliminating the need to reposition the front differential.

Included in this system is Fabtech’s Offset Intrusion Beam Kit that allows use of 33" tires. The factory Intrusion Beams are located in the front fenderwells, forward and back of the tire. They limit the size of the tire you can install while being an integral part of the front collision safety impact feature of the vehicle. Rather than modifying or removing the Beams for tire clearance, Fabtech provides replacement Offset Intrusion Beams. They are constructed of 1/4" thick steel and are a welded box design for maximum strength. They allow full steer with 33/1250R tires w/ a 5" back space wheel.

The rear is lifted using a proven option... a set of 1.5" tall lift blocks and longer U-bolts. This kit also includes Fabtech Performance Series rear shock absorbers.

Fabtech K2323 Features:
Value priced system with Fabtech quality
Increased ground clearance
Tubular UCA design with urethane bushings for quiet ride
Extended range upper ball joints allow for increased travel
Offset Intrusion Beams for full steer tire clearance
Easy bolt on installation

Tire & Wheel Information:
Use 33/12.50R18 tires w/ 18×9 wheels w/ 5″ BS w/ minor trimming
Use 33/12.50R20 tires w/ 20×9 wheels w/ 5″ BS w/ minor trimming

Important Fitment Information - Please Read!

This kit is ONLY for use on Aluminum knuckle equipped models!
Fabtech states this item is ONLY for use on SuperCrew models.

For more information on this or any other Fabtech product please contact us using the Ask A Question link located at the very top of this page.