SPC Toyota Alignment Cam & Bolt Kit # 25445

Specialty Products Company Toyota Alignment Cam and Bolt Kit # 25445. Fits 2000 - 2006 Toyota Tundra and 2001-2007 Toyota Sequoia. SPC offers a less expensive and upgraded alternative to the factory Toyota version while still offering significantly higher quality than the "generic" cam and bolt kits on the market. The eccentric cams are designed to be installed in the lower control arms and can provide both camber and caster adjustment. Each kit will replace one side. This Cam and Bolt kit will provide a Camber/Caster adjustment range of ±1.50°. Installation will require metric basic hand tools. Please note a professional alignment is recommended after this item has been installed.

SPC # 25445 Contents:
1 x D Bolt - 5.00" Length
1 x D Bolt - 4.25" Length
2 x Lock Nuts
4 x D Washers
2 x Plastic Sleeves
1 x Printed Instruction Sheet

If you were paying attention to the Kit Contents listed above you will see that 1 kit is only enough parts for one side of the vehicle. That means if you are replacing the factory bolts on both sides of your Toyota vehicle you will need to purchase 2 x SPC # 25445. Please pay attention to the fitment too... these parts are built specifically for use on the 1999-2006 Toyota Tundra and 2001 - 2007 Toyota Sequoia.

For more information on this or any other Specialty Products Company item please click on the "Ask A Question" link located at the very top of this page.